The D-7
Hydrogen Kit
D - 7 Hydrogen Kit
$635.00
The D-7 Hydrogen Kit is built for 5 to 7.9 liter engine sizes. Ideal for 8 and 10 cylinder engines.
Ruggid housing is built from 3/4" marine grade Starboard polyethylene, this is a much better choice than acrylic or ABS.
13 316L stainless steel plates.
Produces up to 3 LPM.
The amp efficiency calculation of this generator is 12 amps for 1 LPM.
Mounting brackets attached making installation easy.
Comes with custom HHO dryer that is approximately 6" tall, it is installed
right before your air intake.
Demisnsions 7" x 7" x 5" The five inch depth includes the mounting brackets.
This hydrogen fuel saver comes with easy to read instructions and colorful diagrams, and of course we are here to offer you technical support by email
or phone (if needed).
Pulse Width Modulator and More
The Digital Display is to be mounted inside your vehicle.
With this LCD display you will have a continuous read out for:
- Amps
- Voltage
- Duty Cycle
-
A flip of a switch and you can turn your hydrogen kit.
Important safety shut-off feature, turns off the HHO system.
It also has a safety shut-off with 2 ways to detect when the engine isn't running shutting the
HHO system down. This is a very important safety feature that should never be over-looked.
The HHO PWM will allow you to have control over the maximum current that you want to
run for best gas mileage performance. This is a constant current PWM.
Can easily be mounted in a small area under your hood.
Pleas click here to read more about this HHO PWM
Freezing Temperatures For Your Hydrogen Car Kit
What Climate Do You Drive In?
- If it does not get below 20 Degrees Fahrenheit, the mixture should be 18% Sodium Hydroxide.
- For temperatures minus 54 Degrees Fahrenheit, use 28% Potassium Hydroxide.
-
Choices For HHO Computer Enhancement
If your vehicle is fuel injected and has a computer you will need enhancement to see an increase in miles per gallon.
Please see
hydrogen car conversion to understand this better.
The easiest route is probably to install a FS2 HHO chip made especially to go with hydrogen generators.
This plugs into your vehicles computer from inside the cab, behind your OBDII port (usually near your steering column).
The results vary with the FS2 HHO Chip, we see about an 80% success rate.
This is a set it and forget it way to go. With this option you will not need an EFIE or MAF/MAP sensor enhancer.
This HHO chip is programmed for your specific vehicle by year, make, model and liter size engine.
If you ever decide to use it on another vehicle, we can reprogram it for $25.
Bundle The D-7 Hydrogen Generator Kit
and FS2 HHO Chip
 $710.00
Save $15.00
MAP Sensor Enhancer and EFIE Combination
For our customers that want to manually tune the ECU to obtain the best MPG increase, we offer the
MAF or MAP Sensor Enhancers and EFIEs.
You will receive easy to read and understand instructions and technical support (if needed).
To read more on your enhancement options please see our hydrogen car conversion page.
$143.50
MAP Sensor Enhancer and EFIE
MAP Sensor Enhancer or EFIE
$44.50
MAP Sensor Enhancer
|
$99.00
EFIE
|
The S - 7
What's In The Kit?
- The D-7 Cell
- HHO PWM
- Multiple Controller With LCD Display
- 1.5 Quart Reservoir Tank
- Finger Grip Nylon Reservoir Cap
- HHO Dryer
- 12' Reinforced Heavy Duty Fuel Hose 3/8"
- Barbed Elbow For Air Intake 1/4" NPT
- Drain Valve
- 12' of Red Automotive Wire
- 12' of Black Automotive Wire
- Electrical Kit: Connectors, Circuit Breaker etc.
- Mounting screws for D-7 Cell, PWM and LCD Display
- Easy To Understand Installation Instructions
|
